Monitoring the inverter status
102
BASIC OPERATION
4.2 Monitoring the inverter status
4.2.1 Monitoring of output current and output voltage
POINTPOINT
• Pressing in the monitor mode switches the monitored item to output frequency, output current, and then to output
voltage.
NOTE
• Other monitored items, such as output voltage and set frequency, are also available. Use Pr.52 to change the setting. (Refer
to page 359.)
4.2.2 First monitored item
The first monitored item to be displayed in the monitor mode is selectable.
To set a monitored item as the first monitored item, display a monitored item, and press for a while.
NOTE
•Use Pr.774 Operation panel monitor selection 1 to change the monitored item. (Refer to page 359.)
4.2.3 Displaying the set frequency
In the PU operation mode or in the External/PU combined operation mode 1( ) (Pr.79 Operation mode selection
="3"), select the monitor mode, and then press the setting dial. The present set frequency is displayed.
NOTE
•Use Pr.992 Operation panel setting dial push monitor selection to change the displayed indication. (Refer to page 359.)
Operation
1.
Press during operation to monitor the output frequency. [Hz] indicator turns ON.
2.
Press to monitor the output current. This operation is valid during running or stopping under any operation
mode. [A] appears.
3.
Press to monitor the output voltage. [V] appears.
Changing example Set the output current as the first monitored item.
Operation
1. Select the monitor mode, and select the output current.
2.
Press for a while (1 s). The output current is set as the first monitored item.
3. When the monitor mode is selected next time, the output current is monitored first.
To Next Page
Loading...
