(A) Application parameters
546
PARAMETERS
Copying the PLC function project data to USB memory
• This function copies the PLC function project data to a USB memory device.
The PLC function project data copied in the USB memory device can be copied to other inverters.
This function is useful in backing up the parameter setting and for allowing multiple inverters to operate by the same
sequence programs.
• Refer to page 60 for an outline of the USB communication function.
• The following data can be copied by copying the project data via USB memory.
Extension File type
Copy from inverter to
USB memory
Copy from USB memory
to inverter
.QPA Parameter file Supported Supported
.QPG Program file Supported Supported
.C32 Function block source information Supported Supported
.QCD Global text comment information Supported Supported
.DAT Project management information Supported Not available
.TXT Copy information Supported Not available
USB memory mode
Overwrite the inverter project data file onto the
designated file in the USB memory device.
Project data file
number (displays 1
to 99, unrelated to
the number of files
saved in the USB
memory device)
Write the designated project data file of the USB
memory device onto a data file of the inverter.
Verify the designated project data file of the USB
memory device against the project data file of the
inverter.
Monitor mode
Parameter setting mode
Function mode Faults history mode
To Next Page
Loading...
