Mitsubishi FR-A800

(D) Operation command and frequency command
PARAMETERS
305
5
GROUP
D
5.9 (D) Operation command and frequency
command
Purpose Parameter to set
Refer to
page
To select the operation mode Operation mode selection P.D000 Pr.79 306
To start up in Network operation
mode at power-ON
Communication startup
mode selection
P.D000, P.D001 Pr.79, Pr.340 315
To select the command source
during communication operation
Operation and speed
command sources during
communication operation,
command source selection
P.D010 to P.D013
Pr.338, Pr.339,
Pr.550, Pr.551
316
To prevent motor from rotating
reversely
Reverse rotation prevention
selection
P.D020 Pr.78 323
To change the setting resolution
of speed
Set resolution switchover P.D030 Pr.811 357
To change the setting resolution
of the torque limit
Set resolution switchover P.D030 Pr.811 357
To set the frequency by pulse
train input
Pulse train input
P.D100, P.D101,
P.D110, P.D111
Pr.291,
Pr.384 to Pr.386
324
To perform JOG operation JOG operation P.D200, P.F002 Pr.15, Pr.16 327
To control frequency with
combinations of terminals
Multi-speed operation P.D300 to P.D315
Pr.28,
Pr.4 to Pr.6,
Pr.24 to Pr.27,
Pr.232 to Pr.239
328
To select torque command
method during torque control
Torque command source
selection
P.D400 to P.D402 Pr.804 to Pr.806 216