Mitsubishi FR-A800

Torque control under Real sensorless vector control and vector control
PARAMETERS
221
5
Forward/reverse rotation speed limit using analog input (Pr.1113="9999",
Pr.807="2")
• When performing speed limit by analog inputs to terminal 1, speed limit can be switched between forward and reverse
rotation by its voltage polarity.
• When Pr.868 Terminal 1 function assignment ="5", forward/reverse speed limit is enabled.
• If 0 to 10 V is input, forward rotation speed limit is applied. Reverse rotation speed limit at this time is the value of Pr.1
Maximum frequency.
• If -10 to 0 V is input, reverse rotation speed limit is applied. Forward rotation speed limit at this time is the value of Pr.1.
• Upper speed limit is the value of Pr.1 for both forward and reverse rotations.
NOTE
• To perform speed limit by using the terminal 1, calibrate the terminal 1. (Refer to page 415.)
Pr.7
ONOFF
Start signal
Speed
Time
Speed
Forward rotation
Reverse rotation
Output
torque (%)
0
Speed
Reverse rotation
Forward rotation
Output torque (%)
Terminal 1 input
Pr.1
0
Torque controllable range
Torque controllable range
Torque controllable range
Terminal 1
input
Terminal 1 input
(-10 to 0V)
The reverse
rotation speed
limit
150 150
150 150
Pr.1
Pr.8
Pr.1
Pr.7
ONOFF
Start signal
Speed
Time
Terminal 1 input (0 to 10V)
The forward rotation speed
limit
Pr.8
Pr.1
Torque controllable range
When terminal 1 input is "-10 to 0V" When terminal 1 input is "0 to 10V"
The reverse rotation
speed limit
The forward rotation
speed limit