Mitsubishi FR-A800

Check and clear of the faults history
642
PROTECTIVE FUNCTIONS
Faults history clearing procedure
POINTPOINT
•Set Err.CL Fault history clear = "1" to clear the faults history.
Operation
1.
Screen at power-ON
The monitor display appears.
2.
Parameter setting mode
Press to choose the parameter setting mode. (The parameter number read previously appears.)
3.
Selecting the parameter number
Turn until (faults history clear) appears. Press to read the present set value. " " (initial value)
appears.
4.
Faults history clear
Turn to change the set value to " ". Press to start clear.
" " and " " flicker alternately after parameters are cleared.
Turn to read another parameter.
Press to show the setting again.
Press twice to show the next parameter.