Mitsubishi FR-A800

(A) Application parameters
550
PARAMETERS
Analog source (monitored item) selection
• Select the analog sources (monitored items) to be set to Pr.1027 to Pr.1034 from the table below.
 "*" shows a monitored item with a high-speed sampling cycle.
 "" shows that the display with a minus sign is available.
 Indicates a criterion at 100% when the analog trigger is set.
 Refer to Terminal FM, CA, AM Full-scale value (page 370).
 Monitoring is available only for standard models.
 Rated motor frequency  120 / number of motor poles
Setting
value
Monitored item
Minus
sign
display

Trigger
level
criterion

1 Output frequency/speed 
2 Output current 
3 Output voltage 
5
Frequency setting value/speed
setting

6 Running speed 
7 Motor torque 
8 Converter output voltage 
9 Regenerative brake duty 
10
Electronic thermal O/L relay load
factor

11 Output current peak value 
12
Converter output voltage peak
value

13 Input power 
14 Output power 
17 Load meter 
18 Motor excitation current 
19 Position pulse 65535
20 Cumulative energization time 65535
22 Orientation status 65535
23 Actual operation time 65535
24 Motor load factor

32 Torque command 
33 Torque current command 
34 Motor output 
35 Feedback pulse 65535
40 PLC function user monitor 1 

41 PLC function user monitor 2  
42 PLC function user monitor 3  
52 PID set point 
53 PID measured value 
54 PID deviation  
61 Motor thermal load factor 
62 Inverter thermal load factor 
64 PTC thermistor resistance Pr.561
67 PID measured value 2

87 Remote output value 1  
88 Remote output value 2  
89 Remote output value 3  
90 Remote output value 4  
91 PID manipulated variable  
92 Second PID set point 
93 Second PID measured value 
94 Second PID deviation  
95 Second PID measured value 2 
96 Second PID manipulated variable  
97 Dancer main speed setting 
98 Control circuit temperature  
201 *Output frequency Pr.84
202 *U Phase Output Current 
ND rated
current
203 *V Phase Output Current 
ND rated
current
204 *W Phase Output Current 
ND rated
current
205 *Converter Output Voltage 400 V/800 V
206 *Output Current (all three phases)
ND rated
current
207 *Excitation Current(A)
ND rated
current
208 *Torque Current(A)
ND rated
current
209 Terminal 2 100%
210 Terminal 4 100%
211 Terminal 1  100%
212 *Excitation Current (%)  100%
213 *Torque Current (%)  100%
222 Position command 65535
223 Position command (upper digits)  65535
224 Current position 65535
225 Current position (upper digits)  65535
226 Droop pulse 65535
227 Droop pulse (upper digits)  65535
230 *Output Frequency (signed)  Pr.84
231 *Motor Speed 

232 *Speed Command  
235 *Torque Command  100%
236 *Motor Torque  100%
237 *Excitation Current Command  100%
238 *Torque Current Command  100%
Setting
value
Monitored item
Minus
sign
display

Trigger
level
criterion
