Mitsubishi FR-A800

(T) Multi-Function Input Terminal Parameters
PARAMETERS
405
5
GROUP
T
5.12 (T) Multi-Function Input Terminal
Parameters
Purpose Parameter to set
Refer to
page
To inverse the rotation direction
with the voltage/current analog
input selection (terminals 1, 2, and
4)
Analog input selection P.T000, P.T001 Pr.73, Pr.267 406
To assign functions to analog
input terminals
Terminal 1 and terminal 4
function assignment
P.T010, P.T040 Pr.858, Pr.868 410
To adjust the main speed by the
analog auxiliary input
Analog auxiliary input and
compensation (addition
compensation and
override functions)
P.T021, P.T031,
P.T050, P.T051
Pr.73, Pr.242,
Pr.243, Pr.252,
Pr.253
411
To eliminate noise on analog
inputs
Analog input filter P.T002 to P.T007
Pr.74, Pr.822,
Pr.826, Pr.832,
Pr.836, Pr.849
413
To adjust analog input frequency/
voltage (current) (calibration)
Frequency setting voltage
(current) bias and gain
P.T100 to P.T103,
P.T200 to P.T203,
P.T400 to P.T403,
P.M043
Pr.125, Pr.126,
Pr.241, C2 to C7
(Pr.902 to
Pr.905), C12 to
C15 (Pr.917 to
Pr.918)
415
To adjust analog input torque/
voltage (current) (calibration)
Torque setting voltage
(current) bias and gain
P. T 11 0 t o P. T 11 3 ,
P.T410 to P.T413,
P.M043
Pr.241, C16 to
C19 (Pr.919 to
Pr.920), C38 to
C41 (Pr.932 to
Pr.933)
421
To continue operating at analog
current input loss
4-mA input check P.T052 to P.T054
Pr.573, Pr.777,
Pr.778
426
To assign functions to input
terminals
Input terminal function
selection
P. T 7 0 0 t o P. T 7 11 ,
P. T 74 0
Pr.178 to Pr.189,
Pr.699
430
To change the input specification
(NO/NC contact) of input signals
Output stop signal (MRS)
input selection
P. T 72 0 P r. 1 7 433
Inverter run enable signal
(X10) input selection
P.T721 Pr.599 617
Power failure stop external
signal (X48) input
selection
P.T722 Pr.606 540
To enable the second (third)
function only during the constant
speed
RT signal application
period selection
P.T730 Pr.155 434
To assign start and forward/
reverse commands to different
signals
Start signal (STF/STR)
operation selection
P.G106 Pr.250 43
6