Raisecom ISCOM2600G-HI (A) Series - Example for Configuring Interface Protection; Figure 2-22 Interface Protection Networking

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
2 Ethernet
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
126
2.10.7 Example for configuring interface protection
Networking requirements
As shown in Figure 2-22, to prevent PC 1 and PC 2 from interconnecting with each other and
to enable them to interconnect with PC 3 respectively, enable interface protection on GE 1/1/1
and GE 1/1/2 on Switch A.
Figure 2-22 Interface protection networking
Configuration steps
Step 1 Enable interface protection on the GE 1/1/1.
Raisecom#config
Raisecom(config)#interface gigaethernet 1/1/1
Raisecom(config-gigaethernet1/1/1)#switchport protect
Raisecom(config-gigaethernet1/1/1)#exit
Step 2 Enable interface protection on the GE 1/1/2.
Raisecom(config)#interface gigaethernet 1/1/2
Raisecom(config-gigaethernet1/1/2)#switchport protect
Checking results
Use the show switchport protect command to show configurations of interface protection.