Raisecom ISCOM2600G-HI (A) Series User Manual

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
10 Security
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
413
Step
Command
Description
3
Raisecom(config-
gigaethernet1/1/port)#ip
arp-inspection trust
Configure the interface as a trusted
interface. Use the no ip arp-inspection
trust command to configure the interface to
an untrusted interface; in other words, the
interface does not trust the ARP packet.
10.3.5 Configuring static binding of dynamic ARP inspection
Configure static binding of dynamic ARP inspection for the ISCOM2600G-HI series switch
as below.
Step
Command
Description
1
Raisecom#config
Enter global configuration mode.
2
Raisecom(config)#ip arp-inspection
static-config
Enable global static ARP
binding.
3
Raisecom(config)#ip arp-inspection
binding ip-address mask [ mac-
address ] [ vlan vlan-id ]
interface-type interface-number
Configure the static binding.
10.3.6 Configuring dynamic binding of dynamic ARP inspection
Before enabling dynamic binding of dynamic ARP inspection, you need to use the ip
dhcp snooping command to enable DHCP Snooping.
Configure dynamic binding of dynamic ARP inspection for the ISCOM2600G-HI series
switch as below.
Step
Command
Description
1
Raisecom#config
Enter global configuration mode.
2
Raisecom(config)#ip arp-
inspection dhcp-snooping
Enable global dynamic ARP binding.
10.3.7 Configuring protection VLAN of dynamic ARP inspection
Configure protection VLAN of dynamic ARP inspection for the ISCOM2600G-HI series
switch as below.
Step
Command
Description
1
Raisecom#config
Enter global configuration mode.

Raisecom ISCOM2600G-HI (A) Series Specifications

General

Brand	Raisecom
Model	ISCOM2600G-HI (A) Series
Category	Switch
Language	English