Raisecom ISCOM2600G-HI (A) Series - Configuring RIP Timer; Configuring Loop Suppression

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
5 IP services
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
228
Step
Command
Description
5
Raisecom(config-
rip)#redistribute
{ static | connected |
isis | bgp | ospf }
[ metric metric ]
[ route-map map-name ]
[ tag tag-value ]
Configure the policy for redistributing RIP
routes.
6
Raisecom(config-
rip)#default-metric
metric
Configure the default metrics of redistributing
external routes.
By default, it is 1.
7
Raisecom(config-
rip)#auto-summary
Enable automatic aggregation (support RIPv2
only).
By default, it is enabled.
8
Raisecom(config-
rip)#validate-update-
source
Enable the function of checking the source IP
address of received RIP packets.
By default, it is enabled.
5.6.5 Configuring RIP timer
Configure the RIP timer for the ISCOM2600G-HI series switch as below.
Step
Command
Description
1
Raisecom#config
Enter global configuration mode.
2
Raisecom(config)#rout
er rip
Enable RIP, and enter RIP configuration mode.
3
Raisecom(config-
rip)#timers basic
update-time invalid-
time holddown-time
flush-time
Configure the RIP timer.
By default, the update interval is 30s. The invalid
interval is 180s. The suppression interval is 120s.
The refreshing interval is 120s.
5.6.6 Configuring loop suppression
Configure loop suppression for the ISCOM2600G-HI series switch as below.
Step
Command
Description
1
Raisecom#config
Enter global configuration mode.
2
Raisecom(config)#
interface
interface-type
interface-number
Enter interface configuration mode.