Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
ISCOM2600G-HI series switch on the network. You do not need to connect a PC to each
ISCOM2600G-HI series switch.
Telnet services provided by the ISCOM2600G-HI series switch are as below:
Telnet Server: run the Telnet client program on a PC to log in to the ISCOM2600G-HI
series switch, and take configuration and management. As shown in Figure 1-3,
ISCOM2600G-HI series switch is providing Telnet Server service at this time.
Figure 1-3 Networking with device as Telnet server
Before accessing the ISCOM2600G-HI series switch through Telnet, you need to log in to the
ISCOM2600G-HI series switch through the Console interface and start the Telnet service.
Take the following configurations on the ISCOM2600G-HI series switch that needs to start
Telnet service.
Enter global configuration mode.
Raisecom(config)#interface
fastethernet 1/0/1
Enter out-of-band network management
interface configuration mode
Raisecom(config-
fastethernet 1/0/1)#ip
address
ip-address
[
ip-
mask
]
Configure the IP address of the out-of-
band network management interface.
By default, it is 192.168.0.1/24. Both the
default user name and password are
raisecom.
Raisecom(config)#telnet-
server accept
interface-type
interface-list
(Optional) configure the interface in
support of Telnet function.
Raisecom(config)#telnet-
server close terminal-telnet
session-number
(Optional) release the specified Telnet
connection.
Raisecom(config)#telnet-
server max-session
session-
number
(Optional) configure the maximum
number of Telnet sessions supported by
the ISCOM2600G-HI series switch.
By default, it is 10.
Raisecom(config)# telnet-
server access-list {
ip
access-list number
|
ipv6
access-list number
}
(Optional) configure the ACL number of
the Telnet.
Raisecom(config)#telnet-
server disable
(Optional) disable Telnet Server. At the
same time, the corresponding port
number will be disabled.
To Next Page
Loading...
