Raisecom ISCOM2600G-HI (A) Series - Default Configurations of Zero-Configuration; Preparing for Configuration; Figure 6-5 Zero-Configuration Server Networking

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
6 DHCP
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
259
Figure 6-5 Zero-configuration server networking
By default, zero-configuration is enabled on the device. To disable it, configure the
device to common client mode.
6.2.2 Default configurations of zero-configuration
Default configurations of zero-configuration are as below.
Function
Default value
Zero-configuration polling period
2h
Zero-configuration mode
Enable
6.2.3 Preparing for configuration
Scenario
To enable the remote device to automatically apply for the IP address after being powered on,
configure zero-configuration. To configure zero-configuration parameters, see the following
section.
Prerequisite

Connect the device to the DHCP server correctly. Configure the DHCP server correctly.