Raisecom ISCOM2600G-HI (A) Series - Figure 12-10 Networking of Outputting System Log to Log Host

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
12 System management
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
517
Figure 12-10 Networking of outputting system log to log host
Configuration steps
Step 1 Configure the IP address of the ISCOM2600G-HI series switch.
Raisecom#config
Raisecom(config)#interface vlan 1
Raisecom(config-vlan1)#ip address 20.0.0.6 255.0.0.0
Raisecom(config-vlan1)#exit
Step 2 Configure the system log to be output to the log host.
Raisecom(config)#logging on
Raisecom(config)#logging time-stamp log datetime
Raisecom(config)#logging rate-limit 2
Raisecom(config)#logging host 20.0.0.168 warnings
Checking results
Use the show logging command to show configurations of system log.
Raisecom#show logging
Syslog logging: enable
Dropped Log messages: 0
Dropped debug messages: 0
Rate-limited: 2 messages per second
Squence number display: disable
Debug level time stamp: none
Log level time stamp: datetime
Log buffer size: 4kB
Debug level: low
Syslog history logging: disable
Syslog history table size:1
Dest Status Level LoggedMsgs DroppedMsgs Discriminator
-------------------------------------------------------------------------
---
buffer enable informational(6) 10 0 0
console enable informational(6) 10 0 0
trap disable warnings(4) 0 0 0
file enable debugging(7) 17 0 0
Log host information: