Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
By using the mld filter profile profile-number command in interface configuration
mode, you can apply a created MLD profile to the specified interface. A MLD profile
can be applied to multiple interfaces, but only one MLD profile can be applied to one
interface.
Configuring maximum number of groups
The maximum number of groups for the user to join can be applied to the interface or
interface+VLAN.
Configure maximum number of groups for the ISCOM2600G-HI series switch as below.
Enter global configuration mode.
Raisecom(config)#interface
interface-type interface-
number
Enter physical layer interface
configuration mode or LAG
configuration mode.
Raisecom(config-
gigaethernet1/1/port)#mld
filter max-groups
group-
number
[ vlan
vlan-list
]
Apply the maximum number of groups
to the physical interface or
interface+VLAN.
Raisecom(config-port-
channel1)#mld filter max-
groups
group-number
[ vlan
vlan-list
]
Apply the maximum number of groups
to the LAG interface or
interface+VLAN.
Raisecom(config-
gigaethernet1/1/port)#mld
filter max-groups action
{ drop | replace } [ vlan
vlan-list
]
(Optional) configure the action to be
taken when the number of groups for the
physical interface or interface+VLAN to
join exceeds the maximum number of
groups.
Raisecom(config- port-
channel1)#mld filter max-
groups action { drop |
replace } [ vlan
vlan-
list
]
(Optional) configure the action to be
taken when the number of groups for the
LAG interface or interface+VLAN to
join exceeds the maximum number of
groups.
8.8.8 Checking configurations
Use the following commands to check configuration results.
Raisecom#show mld immediate-leave
[
interface-type interface-number
|
port-channel
port-channel-id
]
Show configurations of immediate
leave of MLD.
Raisecom#show mld mrouter
Show information about the
multicast router interface of MLD.
To Next Page
Loading...
Need help?
General
