Raisecom ISCOM2600G-HI (A) Series - Configuring 802.1 X Re-Authentication; Configuring 802.1 X Timers

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
10 Security
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
435
Step
Command
Description
10
Raisecom(config-
gigaethernet1/1/port)#dot1x
keepalive { enable | disable }
Enable or disable 802.1x handshake
on the interface.
11
Raisecom(config-
gigaethernet1/1/port)#dot1x max-
user user-number
Configure the maximum number of
users allowed to be authenticated by
the 802.1x interface.
If 802.1x is disabled in global/interface configuration mode, the interface access
control mode of 802.1x is configured to force interface authorized mode.
10.7.5 Configuring 802.1x re-authentication
Re-authentication is initiated for authorized users. Before enabling re-authentication,
you must ensure that global/interface 802.1x is enabled. Authorized interfaces are
still in this mode during re-authentication. If re-authentication fails, the interfaces are
in unauthorized state.
Configure 802.1x re-authentication for the ISCOM2600G-HI series switch as below.
Step
Command
Description
1
Raisecom#config
Enter global configuration mode.
2
Raisecom(config)#interface
interface-type interface-number
Enter physical layer interface
configuration mode.
3
Raisecom(config-
gigaethernet1/1/port)#dot1x
reauthentication enable
Enable 802.1x re-authentication.
10.7.6 Configuring 802.1x timers
Configure 802.1x timers for the ISCOM2600G-HI series switch as below.
Step
Command
Description
1
Raisecom#config
Enter global configuration mode.
2
Raisecom(config)#interface
interface-type interface-number
Enter physical layer interface
configuration mode.
3
Raisecom(config-
gigaethernet1/1/port)#dot1x
timer reauth-period reauth-
period
Configure the time of the re-
authentication timer.