Raisecom ISCOM2600G-HI (A) Series User Manual

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
12 System management
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
487
Step
Command
Description
3
Raisecom(config)#snmp-
server community com -
name [ view view-
name ] { ro | rw }
Create community name and configure the
corresponding view and authority. Use default
view internet if view view-name option is empty.
12.1.5 Configuring basic functions of SNMPv3
SNMPv3 uses USM over user authentication mechanism. USM comes up with the concept of
access group: one or more users correspond to one access group, each access group configures
the related read, write and announce view; users in access group have access permission in
this view. The user access group to send Get and Set request must have permission
corresponding to the request, otherwise the request will not be accepted.
As shown in Figure 12-2, the network management station uses the normal access from
SNMPv3 to switch and the configuration is as below.

Configure users.

Check the access group to which the user belongs.

Configure view permission for access groups.

Create views.
Figure 12-2 SNMPv3 authentication mechanism
Configure basic functions of SNMPv3 for the ISCOM2600G-HI series switch as below.
Step
Command
Description
1
Raisecom#config
Enter global configuration
mode.

Raisecom ISCOM2600G-HI (A) Series Specifications

General

Brand	Raisecom
Model	ISCOM2600G-HI (A) Series
Category	Switch
Language	English