Raisecom ISCOM2600G-HI (A) Series - Checking Configurations; Maintenance; Example for Configuring ARP

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
5 IP services
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
215
5.3.2 Checking configurations
Use the following commands to check configuration results.
No.
Command
Description
1
Raisecom#show arp [ ip-address |
interface interface-type
interface-number | static ]
Show information about entries in the
ARP address table.
2
Raisecom#show arp local-proxy
[ interface vlan vlan-id ]
Show information about local proxy
ARP.
5.3.3 Maintenance
Maintain the ISCOM2600G-HI series switch as below.
Command
Description
Raisecom(config)#clear arp
Clear all entries in the ARP address table.
5.3.4 Example for configuring ARP
Networking requirements
As shown in Figure 5-2, the ISCOM2600G-HI series switch is connected to the host, and is
also connected to the upstream Router through GE 1/1/1. For the Router, the IP address and
submask are 192.168.1.10/24, and the MAC address is 0050-8d4b-fd1e.
To improve communication security between the Switch and Router, you need to configure
related static ARP entry on the ISCOM2600G-HI series switch.