Raisecom ISCOM2600G-HI (A) Series - Configuring Interface Rate Statistics

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
1 Basic configurations
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
41
Step
Command
Description
2
Raisecom(config)#interface
interface-type interface-
number
Enter physical layer interface
configuration mode.
3
Raisecom(config)#interface
interface-type interface-
number
Enter physical layer interface
configuration mode.
4
Raisecom(config-
gigaethernet1/1/port)#duple
x { full | half | auto }
Configure the duplex mode of the
interface.
5
Raisecom(config-
gigaethernet1/1/port)#speed
{ auto | 10 | 100 | 1000 |
10000 }
Configure the interface rate.
It depends on specifications of the optical
module for the optical interface. When
there is no 10 Gbit/s interface on the
device, it does not support configuring the
10 Gbit/s rate.
6
Raisecom(config-
gigaethernet1/1/port)#tpid
{ 8100 | 9100 | 88a8 }
(Optional) configure the interface TPID.
By default, it is 0x8100.
7
Raisecom(config-
gigaethernet1/1/port)#jumbo
frame frame-size
(Optional) configure the MTU on the
interface. The device supports configuring
MTU on interfaces in batches.
8
Raisecom(config-
gigaethernet1/1/port)#mdi
{ xover | auto | normal }
(Optional) configure the MDI/MDIX mode
of the electrical interface.
9
Raisecom(config-
gigaethernet1/1/port)#vibra
tion-suppress peroid second
(Optional) configure the period for
suppressing vibration on the interface.
10
Raisecom(config)#interface
tunnel interface-number
Create a Tunnel interface.
11
Raisecom(config-
tunnel1/1/1)#tunnel source
ip-address
Configure the source IP address of the
Tunnel interface.
12
Raisecom(config-
tunnel1/1/1)#tunnel
destination ip-address
Configure the destination IP address of the
Tunnel interface.
13
Raisecom(config-
tunnel1/1/1)#tunnel mode
ipv6ip
Configure the encryption type of the
Tunnel interface to IPv6 over IPv4.
1.7.4 Configuring interface rate statistics
Configure interface rate statistics for the ISCOM2600G-HI series switch as below.
Step
Command
Description
1
Raisecom#config
Enter global configuration mode.
2
Raisecom(config)#interface
interface-type interface-number
Enter physical layer interface
configuration mode.