Raisecom ISCOM2600G-HI (A) Series - Filtering Unknown Multicast Packets; Configuring MAC Address Learning; Configuring MAC Address Limit; Configuring Aging Time of MAC Addresses

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
2 Ethernet
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
54
2.1.6 Filtering unknown multicast packets
Filter unknown multicast packets for the ISCOM2600G-HI series switch as below.
Step
Command
Description
1
Raisecom#config
Enter global configuration mode.
2
Raisecom(config)#mac-address
multicast drop-unknown { reserved-
address | vlan vlan-list }
(Optional) filter unknown
multicast packets.
2.1.7 Configuring MAC address learning
Configure MAC address learning for the ISCOM2600G-HI series switch as below.
Step
Command
Description
1
Raisecom#config
Enter global configuration mode.
2
Raisecom(config)#interface
interface-type interface-number
Enter physical layer interface
configuration mode.
3
Raisecom(config-
gigaethernet1/1/port)#mac-address
learning enable { interface-type
interface-number | vlanlist vlan-
list }
Enable MAC address learning.
2.1.8 Configuring MAC address limit
Configure the MAC address limit for the ISCOM2600G-HI series switch as below.
Step
Command
Description
1
Raisecom#config
Enter global configuration mode.
2
Raisecom(config)#interface
interface-type interface-number
Enter physical layer interface
configuration mode.
3
Raisecom(config-
gigaethernet1/1/port)#mac-address
threshold threshold-value
Configure interface-based MAC
address limit.
2.1.9 Configuring aging time of MAC addresses
Configure the aging time of MAC addresses for the ISCOM2600G-HI series switch as below.
Step
Command
Description
1
Raisecom#config
Enter global configuration mode.