EasyManuals Logo

Raisecom ISCOM2600G-HI (A) Series User Manual

Raisecom ISCOM2600G-HI (A) Series
581 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #234 background imageLoading...
Page #234 background image
Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
4 Ring network protection
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
203
Step
Command
Description
1
Raisecom#config
Enter global configuration mode.
2
Raisecom(config)#ethernet
line-protection
line-id
lockout
Lock protection switching. After this
configuration, the traffic is not switched to the
protection line even the working line fails.
3
Raisecom(config)#ethernet
line-protection
line-id
force-switch
Switch the traffic from the working line to the
protection line forcedly.
4
Raisecom(config)#ethernet
line-protection
line-id
manual-switch
Switch the traffic from the working line to the
protection line manually. Its priority is lower
than the one of FS and APS.
5
Raisecom(config)#ethernet
line-protection
line-id
manual-switch-to-work
In non-revertive mode, switch the traffic from
the protection line to the working line.
6
Raisecom(config)#clear
ethernet line-protection
line-id
end-to-end command
Clear end-to-end switching control
commands, including lockout, force-switch,
manual-switch, and manual-switch-to-
work.
By default, traffic is automatically switched to the protection line when the working
line fails. Therefore, you need to configure ELPS switching control in some special
cases.
4.2.7 Checking configurations
Use the following commands to check configuration results.
No.
Command
Description
1
Raisecom#show ethernet line-
protection [
line-id
]
Show configurations of the
protection line.
2
Raisecom#show ethernet line-
protection [
line-id
] statistics
Show protection line statistics.
3
Raisecom#show ethernet line-
protection [
line-id
] aps
Show APS information.
4.2.8 Maintenance
Maintain the ISCOM2600G-HI series switch as below.
Command
Description
Raisecom(config)#clear
ethernet line-protection
[
line-id
] statistics
Clear protection line statistic, including Tx APS
packets, Rx APS packets, latest switching time,
latest status switching time.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Raisecom ISCOM2600G-HI (A) Series and is the answer not in the manual?

Raisecom ISCOM2600G-HI (A) Series Specifications

General IconGeneral
BrandRaisecom
ModelISCOM2600G-HI (A) Series
CategorySwitch
LanguageEnglish

Related product manuals