Raisecom ISCOM2600G-HI (A) Series - Configuring OSPF Route Attributes

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
5 IP services
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
237
Step
Command
Description
3
Raisecom(config-router-
ospf)#network ip-address wild-card-
mask area area-id
Configure the network segment
included by the OSPF area.

If you manually configure the router-id by configuring optional parameters in the
router ospf process-id [ router-id router-id ] command, the OSPF process will
use the router-id by precedence. Otherwise, the process will automatically elect a
router-id.

If the process has configured or elected the router-id, and you modify the router-id,
the modification will take effect after restart.
5.7.3 Configuring OSPF route attributes
Configuring interface cost
Configure the interface cost for the ISCOM2600G-HI series switch as below.
Step
Command
Description
1
Raisecom#config
Enter global configuration mode.
2
Raisecom(config)#interface
interface-type interface-number
Enter Layer 3 interface
configuration mode.
3
Raisecom(config-
gigabitethernet1/1/port)#ip
ospf cost cost
Configure the route cost of the IP
interface.
By default, it is not configured.
Configuring reference bandwidth
Configure the OSPF reference bandwidth for the ISCOM2600G-HI series switch as below.
Step
Command
Description
1
Raisecom#config
Enter global configuration mode.
2
Raisecom(config)#router ospf
process-id [ router-id router-id ]
Start an OSPF process, and enter
OSPF configuration mode.
3
Raisecom(config-router-
ospf)#reference-bandwidth
bandwidth
Configure the reference
bandwidth of the link.
By default, it is 110 Mbit/s.