Raisecom ISCOM2600G-HI (A) Series - Configuring Filter; Checking Configurations

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
10 Security
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
402
Step
Command
Description
2
Raisecom(config)#interface interface-type
interface-number time-range time-range-name
hour minute seconds to hour minute seconds
{ weekday-list | sun | mon | tue | wed | thu
| fri | sat | off-day | working-day | daily }
[ from hour minute seconds month-day-year ]
[ to hour minute seconds month-day-year ] to
hour minute seconds month-day-year
Create a period for
applying ACL rules.
10.1.5 Configuring filter
Configure the filter for the ISCOM2600G-HI series switch as below.
Step
Command
Description
1
Raisecom#config
Enter global configuration mode.
2
Raisecom(config)#interface
interface-type interface-number
Enter interface configuration
mode. You can use this command
on the VLAN interface.
3
Raisecom(config-
gigaethernet1/1/port)#filter
{ egress | ingress } access-list
acl-number [ statistics ]
Apply ACL on the interface.
10.1.6 Checking configurations
Use the following commands to check configuration results.
No.
Command
Description
1
Raisecom#show access-list [ acl-
number ]
Show ACL configurations.
2
Raisecom#show acl resource { egress |
ingress }
Show resources used by
ACL.
3
Raisecom#show filter interface
Show filter configurations.
Raisecom#show filter interface
interface-type interface-number
[ ingress | egress ]
Raisecom#show filter interface
interface-type interface-number
[ ingress | egress ]
4
Raisecom#show local-access access-list
Show information about
authentication by the SNMP
server.