Raisecom ISCOM2600G-HI (A) Series - Configuring Ethernet Locked Signal

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
9 OAM
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
380
Step
Command
Description
4
Raisecom(config-
service)#service ais
period { 1 | 60 }
Configure the AIS delivery period.
By default, the period for sending AIS is 1s.
5
Raisecom(config-
service)#service ais
level level
Configure the level of the customer layer MD to
which AIS is sent.

Configuring AIS on the customer-layer device
Step
Command
Description
1
Raisecom#config
Enter global configuration mode.
2
Raisecom(config)#service
cis-id level level
Enter service instance configuration mode.
3
Raisecom(config-
service)#service suppress-
alarms enable mep { mep-id
| all }
Enable alarm suppression.
By default, this function is enabled.
9.3.9 Configuring Ethernet locked signal

Configuring Ethernet locked signal on the server-layer device
Step
Command
Description
1
Raisecom#config
Enter global configuration mode.
2
Raisecom(config)#serv
ice cisid level level
Enter service instance configuration mode.
3
Raisecom(config-
service)#service lck
start mep { all |
mep-list }
Enable the function of sending LCK packets.
By default, this function is disabled.
4
Raisecom(config-
service)#service lck
period { 1 | 60 }
Configure the period for sending LCK packets.
By default, the period for sending LCK packets is
1s.
5
Raisecom(config-
service)#service lck
level level
Configure the level of LCK which is sent to the
client-level MD.

Configuring Ethernet locked signal on the client-layer device
Step
Command
Description
1
Raisecom#config
Enter global configuration mode.
2
Raisecom(config)#service
cis-id level level
Enter service instance configuration mode.