Raisecom ISCOM2600G-HI (A) Series - Configuring GVRP; Checking Configurations

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
2 Ethernet
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
148
2.14.5 Configuring GVRP
Configure GVRP for the ISCOM2600G-HI series switch as below.
Step
Command
Description
1
Raisecom#config
Enter global configuration mode.
2
Raisecom(config)#gvrp enable
Enable global GVRP.
3
Raisecom(config)#interface
interface-type interface-number
Enter physical layer interface
configuration mode.
4
Raisecom(config-
gigaethernet1/1/port)#switchport
mode trunk
Configure the interface to Trunk
mode.
5
Raisecom(config-
gigaethernet1/1/port)#gvrp
registration { fixed | forbidden |
normal }
(Optional) configure GVRP
registration mode.
6
Raisecom(config-
gigaethernet1/1/port)#gvrp enable
Enabling interface GVRP.

Interface GVRP can be enabled only after the interface is configured to Trunk
mode.

We do not recommend enabling GVRP on a LAG member interface.
2.14.6 Checking configurations
Use the following commands to check configuration results.
No.
Command
Description
1
Raisecom#show garp [ interface-
type interface-number ]
Show configurations of the
GARP timer.
2
Raisecom#show garp [ interface-
type interface-number ] statistics
Show GARP statistics.
3
Raisecom#show gvrp [ interface-
type interface-number ]
Show GVRP configurations.
4
Raisecom#show gvrp [ interface-
type interface-number ] statistics
Show GVRP statistics.
5
Raisecom#show gvrp local-vlan
interface-type interface-number
Show the local VLAN of GMRP.