Raisecom ISCOM2600G-HI (A) Series User Manual

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
1 Basic configurations
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
10

enable | disable form: be provided behind a command or in the middle of a command.
The enable parameter is used to enable some feature or function while the disable
parameter is used to disable some feature or function.
For example:

In physical layer interface configuration mode, the description string command is used
to modify descriptions about an interface while the no description command is used to
delete descriptions about the interface and restore to the default values.

In physical layer interface configuration mode, the shutdown command is used to
disable an interface while the no shutdown command is used to enable an interface.

In global configuration mode, the terminal page-break enable command is used to
enable page-break while the terminal page-break disable command is used to disable
terminal page-break.
Most configuration commands have default values, which often are restored by the
no form.
1.1.9 Logging commands
Configure command logging for the ISCOM2600G-HI series switch as below.
Step
Command
Description
1
Raisecom#config
Enter global configuration mode.
2
Raisecom(config)#command-log enable
Enable command logging.
1.2 Accessing device
1.2.1 Introduction
The ISCOM2600G-HI series switch can be configured and managed in Command Line
Interface (CLI) mode or NView NNM network management mode.
The ISCOM2600G-HI series switch CLI mode has a variety of configuration modes:

Console mode: it must use Console mode in the first configuration.

Telnet mode: log on through the Console mode, open Telnet service on the Switch,
configure the IP address of the VLAN interface, configure the user name and password,
and then take remote Telnet configuration.

SSH mode: before accessing the ISCOM2600G-HI series switch through SSH, you need
to log in to the ISCOM2600G-HI series switch and start SSH services through the
Console interface.
When configuring the ISCOM2600G-HI series switch in network management mode, you
must first configure the IP address of the VLAN interface on CLI, and then configure the
ISCOM2600G-HI series switch through NView NNM network management platform.

Raisecom ISCOM2600G-HI (A) Series Specifications

General

Brand	Raisecom
Model	ISCOM2600G-HI (A) Series
Category	Switch
Language	English