Raisecom ISCOM2600G-HI (A) Series User Manual

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
12 System management
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
504
Step
Command
Description
1
Raisecom#config
Enter global configuration mode.
2
Raisecom(config)#lldp
enable
Enable global LLDP.
12.3.5 Enabling interface LLDP
Enable interface LLDP for the ISCOM2600G-HI series switch as below.
Step
Command
Description
1
Raisecom#config
Enter global configuration mode.
2
Raisecom(config)#interface
interface-type interface-number
Enter physical layer interface
configuration mode.
3
Raisecom(config-
gigaethernet1/1/1)#lldp enable
Enable LLDP on an interface.
12.3.6 Configuring basic functions of LLDP
When configuring the delay timer and period timer, the value of the delay timer
should be smaller than or equal to a quarter of the period timer value.
Configure basic functions of LLDP for the ISCOM2600G-HI series switch as below.
Step
Command
Description
1
Raisecom#config
Enter global configuration mode.
2
Raisecom(config)#lldp
message-transmission
interval period
(Optional) configure the period timer of the
LLDP packet.
3
Raisecom(config)#lldp
message-transmission
delay period
(Optional) configure the delay timer of the LLDP
packet.
4
Raisecom(config)#lldp
message-transmission
hold-multiplier hold-
multiplier
(Optional) configure the aging coefficient of the
LLDP packet.
5
Raisecom(config)#lldp
restart-delay period
(Optional) restart the timer. When configuring the
delay timer and period timer, the value of the
delay timer should be smaller than or equal to a
quarter of the period timer value.

Raisecom ISCOM2600G-HI (A) Series Specifications

General

Brand	Raisecom
Model	ISCOM2600G-HI (A) Series
Category	Switch
Language	English