Raisecom ISCOM2600G-HI (A) Series - Checking Configurations; Maintenance

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
8 Multicast
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
329
Step
Command
Description
8
Raisecom(config-
gigaethernet1/1/port)#igmp
immediate-leave vlan vlan-list
(Optional) configure immediate leave.
If immediate leave is disabled on the
downlink interface, the router
interface, after receiving a Leave
packet, will calculate the aging time
according to robust factor and
configure the expiration time for a
member to leave the group as Group
Membership Interval (GMI). GMI =
robust-value*lastmember-
queryinterval.
8.2.5 Checking configurations
Use the following commands to check configuration results.
No.
Command
Description
1
Raisecom#show igmp configuration
Show IGMP basic configurations.
2
Raisecom#show igmp mrouter
Show configurations of the
multicast route interface.
3
Raisecom#show igmp immediate-
leave [ interface-type interface-
number ]
Show configuration of immediate
leave on Layer 2 multicast.
4
Raisecom#show igmp statistics
[ interface-type interface-
number ]
Show Layer 2 multicast statistics.
5
Raisecom#show igmp snooping
mrouter vlan-priority
Show the CoS priority of the
IGMP route VLAN.
6
Raisecom#show igmp ring
Show information about the
IGMP ring network.
8.2.6 Maintenance
Maintain the ISCOM2600G-HI series switch as below.
Command
Description
Raisecom(config)#clear igmp statistics
[ interface-type interface-number ]
Clear statistics about Layer 2 multicast
IGMP.
Raisecom(config)#no igmp member
interface-type interface-number
Delete a specified multicast entry.