Raisecom ISCOM2600G-HI (A) Series - Enabling Suppression of MAC Address Flapping; Checking Configurations; Maintenance

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
2 Ethernet
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
55
Step
Command
Description
2
Raisecom(config)#mac-address
aging-time { 0 | period }
Configure the aging time of MAC
addresses.
2.1.10 Enabling suppression of MAC address flapping
Enable suppression of MAC address flapping for the ISCOM2600G-HI series switch as below.
Step
Command
Description
1
Raisecom#config
Enter global configuration mode.
2
Raisecom(config)#mac-address
mac-move enable
Enabling global suppression of
MAC address flapping.
2.1.11 Checking configurations
Use the following commands to check configuration results.
No.
Command
Description
1
Raisecom#show mac-address static
[ interface-type interface-number
| vlan vlan-id ]
Show static unicast MAC addresses.
2
Raisecom#show mac-address
multicast [ vlan vlan-id ]
[ count ]
Show Layer 2 multicast addresses
or the number of existing multicast
MAC address.
3
Raisecom#show mac-address
blackhole
Show the blackhole MAC address.
4
Raisecom#show mac-address
threshold [ interface-type
interface-number | vlan vlan-
list ]
Show the dynamic MAC address
limit.
5
Raisecom#show mac-address aging-
time
Show the aging time of dynamic
MAC addresses.
6
Raisecom#show mac-address learning
[ interface-type interface-
list ][ vlan ]
Show status of MAC address
learning.
7
Raisecom#show mac-address count
[ vlan vlan-id ] [ interface-type
interface-number ]
Show the number of MAC address
entries.
2.1.12 Maintenance
Maintain the ISCOM2600G-HI series switch as below.