Raisecom ISCOM2600G-HI (A) Series - Example for Configuring Static Route; Figure 5-4 Configuring Static Route

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
5 IP services
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
222
No.
Item
Description
Raisecom#show ipv6 route { ipv6-address
| ipv6-address / prefix-length }
route to a destination.
6
Raisecom#show ip fib [ ip-address |
nexthop ip-address ]
Show information about
FIB entries.
Raisecom#show ipv6 fib [ ipv6-address |
nexthop ipv6-address ]
7
Raisecom#show ip fib summary
Show statistics in the
routing table.
Raisecom#show ipv6 fib summary
5.5.6 Example for configuring static route
Networking requirements
Configure the static route to enable any two hosts or ISCOM2600G-HI series switch devices
successfully to ping through each other, as shown in Figure 5-4.
Figure 5-4 Configuring static route
Configuration steps
Step 1 Configure the IP address of each device. Detailed configurations are omitted.
Step 2 Configure the static route on Switch A.