Raisecom ISCOM2600G-HI (A) Series User Manual

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
5 IP services
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
218
Prerequisite

Connect interfaces.

Configure physical parameters to make interfaces Up at the physical layer.

Configure the IPv6 address of the Layer 3 interface.
5.4.3 Default configurations of NDP
Default configurations of NDP are as below.
Function
Default value
Times of sending NS messages for detecting duplicated addresses
1
Maximum number of NDPs allowed to learn
512
5.4.4 Configuring static neighbor entries
To resolute the IPv6 address of a neighbor into the data link layer address, you can use the NS
message and NA message, or manually configure static neighbor entries.
Configure static neighbor entries for the ISCOM2600G-HI series switch as below.
Step
Command
Description
1
Raisecom#config
Enter global configuration mode.
2
Raisecom(config)#ipv6 neighbor
ipv6-address mac-address
configure static neighbor entries
5.4.5 Configuring times of sending NS messages for detecting
duplicated addresses
Configure times of sending NS messages for detecting duplicated addresses for the
ISCOM2600G-HI series switch as below.
Step
Command
Description
1
Raisecom#config
Enter global configuration mode.
2
Raisecom(config-vlan1)#ipv6
nd dad attempts value
Configure times of sending NS messages
for detecting duplicated addresses.
When the ISCOM2600G-HI series switch obtains an IPv6 address, it uses the
duplicated address detection function to determine whether the IPv6 address is
already used by another device. After sending NS messages for a specified times
and receiving no response, it determines that the IPv6 address is not duplicated and
thus can be used.

Raisecom ISCOM2600G-HI (A) Series Specifications

General

Brand	Raisecom
Model	ISCOM2600G-HI (A) Series
Category	Switch
Language	English