Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Raisecom(config)#interface gigaethernet 1/1/2
Raisecom(config-gigaethernet1/1/2)#igmp mvr
Raisecom(config-tengigabitethernet1/1/2)#igmp mvr user-vlan 13
Raisecom(config-gigaethernet1/1/2)#exit
Raisecom(config)#igmp mvr mcast-vlan 3
group
any
Step 3 Configure the IGMP filtering profile.
Raisecom(config)#igmp filter profile 1
Raisecom(config-igmp-profile)#permit
Raisecom(config-igmp-profile)#range 1 234.5.6.7 234.5.6.10
Raisecom(config-igmp-profile)#exit
Step 4 Configure the STB to apply the IGMP filtering profile.
Raisecom(config)#igmp filter
Raisecom(config)#interface gigaethernet 1/1/1
Raisecom(config-gigaethernet1/1/1)#igmp filter profile 1
Step 5 Configure the maximum number of multicast groups on the STB interface.
Raisecom(config-gigaethernet1/1/1)#igmp filter max-groups 1
Raisecom(config-gigaethernet1/1/1)#igmp filter max-groups action replace
Checking results
Use the following command to show configurations of IGMP filtering on the interface.
Raisecom#show igmp filter gigaethernet 1/1/1
igmp profile: 1
max group: 1
current group: 0
action: replace
8.7 Multicast VLAN copy
8.7.1 Introduction
Multicast VLAN copy refers to specifying different VLANs as one user VLAN of the
multicast VLAN when different user VLANs require the same multicast source on the switch.
To Next Page
Loading...
Need help?
General
