Raisecom ISCOM2600G-HI (A) Series - Configuring Sticky Secure MAC Address

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
10 Security
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
407
Step
Command
Description
5
Raisecom(config-
gigaethernet1/1/port)#switchport
port-security
(Optional) enable port dynamic
security MAC learning.
6
Raisecom(config-
gigaethernet1/1/port)#switchport
port-security trap enable
(Optional) enable port security
MAC Trap.
7
Raisecom(config-
gigaethernet1/1/port)#switchport
port-security trap period value
(Optional) configure the period for
sending Traps for port security
MAC.
8
Raisecom(config-
gigaethernet1/1/port)#switchport
port-security trap period value
(Optional) configure the period for
sending Traps on the interface.
The switchport port-security command can enable port security MAC and dynamic
secure MAC learning at the same time.
10.2.7 Configuring sticky secure MAC address
We do not recommend configuring sticky secure MAC addresses when port sticky
security MAC is disabled. Otherwise, port sticky security MAC may malfunction.
Configure the sticky secure MAC address for the ISCOM2600G-HI series switch as below.
Step
Command
Description
1
Raisecom#config
Enter global configuration
mode.
2
Raisecom(config)#interface interface-
type interface-number
Enter physical layer interface
configuration mode.
3
Raisecom(config-
gigaethernet1/1/port)#switchport
port-security
Enable port security MAC.
4
Raisecom(config-
gigaethernet1/1/port)#switchport
port-security mac-address sticky
Enable sticky secure MAC
learning.
5
Raisecom(config-
gigaethernet1/1/port)#switchport
port-security mac-address sticky mac-
address vlan vlan-id
(Optional) manually
configure sticky secure MAC
addresses.