Raisecom ISCOM2600G-HI (A) Series User Manual

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
2 Ethernet
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
133
Applying a profile to an interface takes effect unless global L2CP is enabled. You can
configure it but it will not take effect if global L2CP is disabled.
2.12.7 Checking configurations
Use the following commands check configuration results.
No.
Command
Description
1
Raisecom#show l2cp-process profile
[ profile-number ]
Show information about the
created L2CP profile.
2
Raisecom#show l2cp-process
[ interface-type interface-number ]
Show configurations of L2CP on
the interface.
3
Raisecom#show l2cp-process
[ tunnel statistics ] [ interface-
type interface-number ]
Show statistics about L2CP
packets on the interface.
2.12.8 Maintenance
Maintain the ISCOM2600G-HI series switch as below.
Command
Description
Raisecom(config)#clear l2cp-process tunnel
statistic [ interface-type interface-number ]
Clear statistics about L2CP
packets on the interface.
2.12.9 Example for configuring L2CP
Networking requirements
As shown in Figure 2-25, configure L2CP on Switch A and Switch B as below.

Specify the multicast destination MAC address of them to 0100.1234.1234.

Configure the STP packets of Customer A to traverse the MAN, and discard other
packets.

Configure the STP and VTP packets of Customer B to traverse the MAN, send elmi
packets to the CPU, and discard other packets.

Raisecom ISCOM2600G-HI (A) Series Specifications

General

Brand	Raisecom
Model	ISCOM2600G-HI (A) Series
Category	Switch
Language	English