Raisecom ISCOM2600G-HI (A) Series User Manual

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
9 OAM
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
388
is for service packets of the UNI interface. For Down MEP, the statistics result is for
service packets of the NNI interface.

Packet loss ratio is for service packets, so SLA protocol packets should not be discarded.
If SLA protocol packets are discarded, packet loss rate cannot be tested.
9.4.4 Default configurations of SLA
Default configurations of SLA are as below.
Function
Default value
SLA operation scheduling status
Disable
SLA Layer 2 operation CoS
0
Probe interval for SLA packet loss
operations
1s
Life period for scheduling SLA operations
Forever
Test period for scheduling SLA operations
300s
SLA alarm status

Availability status change alarm: disable

Threshold alarm status: disable
9.4.5 Creating SLA operation
Create an SLA operation for the ISCOM2600G-HI series switch as below.
All following steps are optional and in any sequence.
Step
Command
Description
1
Raisecom#config
Enter global configuration
mode.
2
Raisecom(config)#sla oper-num
y1731–pkt-loss slm remote-mac mac-
address level level-id svlan vlan-
id [ cos cos-value ] [ interval
interval-num ] [ size size ]
(Optional) configure SLA
Y1731-pkt-loss operation
according to the destination
MAC address.
3
Raisecom(config)#sla oper-num
y1731–pkt-loss slm remote-mep mep-
num level level-id svlan vlan-id
[ cos cos-value ] [ interval
interval-num ] [ size size ]
(Optional) configure SLA
Y1731-pkt-loss operation
according to the destination
MEP.
4
Raisecom(config)#sla oper-num owner
description string
(Optional) configure the
description of the SLA
operation user.
5
Raisecom(config)#sla private-tlv
enable
(Optional) enable the function
of padding the SLA operation
with the private TLV.
By default, this function is
disabled.

Raisecom ISCOM2600G-HI (A) Series Specifications

General

Brand	Raisecom
Model	ISCOM2600G-HI (A) Series
Category	Switch
Language	English