Raisecom ISCOM2600G-HI (A) Series - Enabling Dhcpv4 Server on VLAN Interface; Enabling DHCP Server on VLAN Interface; Configuring DHCP Server to Support Option 82; Checking Configurations

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
6 DHCP
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
279
6.5.4 Enabling DHCPv4 Server on VLAN interface
Enable DHCPv6 Server on the VLAN interface for the ISCOM2600G-HI series switch as
below.
Step
Command
Description
1
Raisecom#config
Enter global configuration mode.
2
Raisecom(config)#interface vlan
vlan-id
Enter VLAN interface configuration
mode.
3
Raisecom(config-vlan1)#ip dhcp
server
Enable DHCPv4 Server on the
VLAN interface.
6.5.5 Enabling DHCP Server on VLAN interface
Only global DHCP Server and Layer 3 interface DHCP Server are enabled can the Layer 3
interface receive and process DHCP request packets from clients.
Enable DHCP Server on the VLAN interface for the ISCOM2600G-HI series switch as below.
Step
Command
Description
1
Raisecom#config
Enter global configuration mode.
2
Raisecom(config)#interface vlan
vlan-id
Enter VLAN interface configuration
mode.
3
Raisecom(config-vlan1)#ip dhcp
server
Enable DHCP Server on the VLAN
interface.
6.5.6 Configuring DHCP Server to support Option 82
Configure DHCP Server to support Option 82 for the ISCOM2600G-HI series switch as
below.
Step
Command
Description
1
Raisecom#config
Enter global configuration mode.
2
Raisecom(config)#ip dhcp server
information option
Configure DHCP Server to support
Option 82.
6.5.7 Checking configurations
Use the following commands to check configuration results.