Raisecom ISCOM2600G-HI (A) Series - Checking Configurations

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
10 Security
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
454
Step
Command
Description
3
Raisecom(config-vlan1)#arp
learning strict enable
Enable the device to learn ARP
entries requested by itself.
4
Raisecom(config-vlan1)#arp check-
destination-ip enable
Enable the check of ARP destination
IP address.
5
Raisecom(config-vlan1)#arp filter
{ gratuitous | mac-illegal | tha-
filled-request }
Configure ARP filtering.
6
Raisecom(config-vlan1)#arp anti-
attack entry-check { fixed-all |
fixed-mac | send-ack }
Configure the fixing of ARP entries.
7
Raisecom(config-vlan1)#ip arp-
rate-limit rate rate value
Configure rate limiting of ARP.
10.11.3 Checking configurations
Use the following commands to check configuration results.
No.
Command
Description
1
Raisecom#show arp
Show ARP information.
2
Raisecom#show ip arp filter
Show information about ARP filtering.