Raisecom ISCOM2600G-HI (A) Series User Manual

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
1 Basic configurations
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
42
Step
Command
Description
3
Raisecom(config-
gigaethernet1/1/port)#clear
interface statistics
Clear statistics about the interface
rate.
1.7.5 Configuring flow control on interfaces
IEEE 802.3x is a flow control method for full duplex on the Ethernet data layer. When the
client sends a request to the server, it will send the PAUSE frame to the server if there is
system or network jam. Then, it delays data transmission from the server to the client.
Configure flow control on interfaces for the ISCOM2600G-HI series switch as below.
Step
Command
Description
1
Raisecom#config
Enter global configuration mode.
2
Raisecom(config)#interface
interface-type interface-number
Enter physical layer interface
configuration mode.
3
Raisecom(config-
gigaethernet1/1/port)#flowcontrol
{ receive | send } { off | on }
Enable/Disable interface flow
control over 802.3x packets.
By default, it is disabled.
1.7.6 Shutting down/Restarting interface
Shut down/Restart an interface for the ISCOM2600G-HI series switch as below.
Step
Command
Description
1
Raisecom#config
Enter global configuration mode.
2
Raisecom(config)#interface
interface-type interface-number
Enter physical layer interface
configuration mode.
3
Raisecom(config-
gigaethernet1/1/port)#shutdown
Shut down the current interface.
Use the no shutdown command to
re-enable the disabled interface.
1.7.7 Configuring Console interface
Configure the Console interface for the ISCOM2600G-HI series switch as below.
Step
Command
Description
1
Raisecom#config
Enter global configuration mode.

Raisecom ISCOM2600G-HI (A) Series Specifications

General

Brand	Raisecom
Model	ISCOM2600G-HI (A) Series
Category	Switch
Language	English