Raisecom ISCOM2600G-HI (A) Series User Manual

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
2 Ethernet
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
125
2.10.4 Configuring interface protection
Interface protection is unrelated with the VLAN to which the interface belongs.
Configure interface protection for the ISCOM2600G-HI series switch as below.
Step
Command
Description
1
Raisecom#config
Enter global configuration mode.
2
Raisecom(config)#inte
rface interface-type
interface-number
Enter physical layer interface configuration mode.
3
Raisecom(config-
gigaethernet1/1/port)
#switchport protect
Enable interface protection. Interface isolation is
supported across devices in the ISF. Interface
isolation can be implemented based on LAG
interface, namely, between LAG interfaces, and
between a LAG interface and common interface.
2.10.5 Configuring interface isolation
Configure interface isolation for the ISCOM2600G-HI series switch as below.
Step
Command
Description
1
Raisecom#config
Enter global configuration mode.
2
Raisecom(config)#protect-
group group-id vlan vlan-id
interface-type interface-
number
Create an interface isolation group. Configure
isolation VLANs associated with the group
and the list of isolated interfaces.
2.10.6 Checking configurations
Use the following commands to check configuration results.
No.
Command
Description
1
Raisecom#show switchport
protect
Show configurations of interface protection.
2
Raisecom#show protect-
group { all | group-id }
Show configurations of interface isolation.

Raisecom ISCOM2600G-HI (A) Series Specifications

General

Brand	Raisecom
Model	ISCOM2600G-HI (A) Series
Category	Switch
Language	English