Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
The severity of output information can be manually configured. When you send
information according to the configured severity, you can just send the information
whose severity is less than or equal to that of the configured information. For
example, when the information is configured with the level 3 (or the severity is errors),
the information whose level ranges from 0 to 3, in other words, the severity ranges
from emergencies to errors, can be sent.
12.5.2 Preparing for configurations
Scenario
The ISCOM2600G-HI series switch generates the login successes or failures, key information,
debugging information, and error information to system log, outputs them as log files, and
sends them to the logging host, Console interface, or control console to facilitate checking and
locating faults.
Prerequisite
N/A
12.5.3 Default configurations of system log
Default configurations of system log are as below.
Output log information to Console
Enable, the default level is information (6).
Output log information to host
N/A, the default level is information (6).
Output log information to file
Enable, the default level is debugging (7).
Output log information to monitor
Disable, the default level is information (6).
Output log information to buffer
Disable, the default level is information (6).
Output log information to history list
Disable. The default level is warning (4).
Transmitting rate of system log
Timestamp of system log information
Debug: no timestamp to debug level (7)
Syslog information.
Log: The timestamp to 0–6 levels Syslog
information is absolute time.
To Next Page
Loading...
Need help?
General
