Raisecom ISCOM2600G-HI (A) Series User Manual

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
8 Multicast
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
337
Function
Default value
IGMP Querier status
Disable
IGMP packet suppression status
Disable
Source IP address for IGMP Querier to send
packets
Use the IP address of IP address 0.
If IP interface 0 is not configured,
use 0.0.0.0.
IGMP query interval
125s
Maximum response time to send Query packets
10s
Interval for the last member to send Query packets
1s
8.4.4 Configuring IGMP Querier
Configure IGMP Querier for the ISCOM2600G-HI series switch as below.
Step
Command
Description
1
Raisecom#config
Enter global configuration mode.
2
Raisecom(config)#igmp
querier
Enable IGMP Querier.
3
Raisecom(config)#igmp
source-ip ip-address
(Optional) configure the source IP address for the
IGMP querier to send Query packets.
4
Raisecom(config)#igmp
querier query-
interval seconds
(Optional) configure the IGMP query interval.
5
Raisecom(config)#igmp
querier query-max-
response-time seconds
(Optional) configure the maximum response time
to send Query packets.
6
Raisecom(config)#igmp
querier last-member-
query-interval
seconds
(Optional) configure the interval for the last
member to send Query packets.
7
Raisecom(config)#igmp
proxy
Configure IGMP proxy.

When IGMP Querier is disabled, the following parameters can be configured:
source IP address, query interval, maximum response time to send Query packets,
and interval for the last member to send Query packets. After IGMP Querier is
enabled, these configurations will take effect immediately.

Though IGMP Snooping or IGMP MVR is enabled, IGMP Querier can be still
enabled.

IGMP Proxy and IGMP Querier are mutually exclusive. IGMP Proxy and IGMP
report suppression are mutually exclusive.

Raisecom ISCOM2600G-HI (A) Series Specifications

General

Brand	Raisecom
Model	ISCOM2600G-HI (A) Series
Category	Switch
Language	English