Raisecom ISCOM2600G-HI (A) Series - Preparing for Configurations; Default Configurations of Watchdog; Configuring Watchdog; Checking Configurations

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
1 Basic configurations
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
47
1.10.2 Preparing for configurations
Scenario
By configuring Watchdog, you can prevent the system program from endless loop due to
uncertain fault, thus improving system stability.
Prerequisite
N/A
1.10.3 Default configurations of Watchdog
Default configurations of Watchdog are as below.
Function
Default value
Watchdog status
Enable
1.10.4 Configuring Watchdog
Configure Watchdog for the ISCOM2600G-HI series switch as below.
Step
Command
Description
1
Raisecom#watchdog enable
Enable Watchdog.
1.10.5 Checking configurations
Use the following command to check configuration results.
Step
Command
Description
1
Raisecom#show watchdog
Show Watchdog status.
1.11 Configuring Banner
1.11.1 Preparing for configurations
Scenario
Banner is a message to display when you log in to or exit the ISCOM2600G-HI series switch,
such as the precautions or disclaimer.