Raisecom ISCOM2600G-HI (A) Series - Figure 11-5 Interface Backup Networking

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
11 Reliability
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
468
Figure 11-5 Interface backup networking
Configuration steps
Step 1 Create VLANs 100–400, and add GE 1/1/1 and GE 1/1/2 to these VLANs.
Raisecom#config
Raisecom(config)#create vlan 100-200 active
Raisecom(config)#interface gigaethernet 1/1/1
Raisecom(config-gigaethernet1/1/1)#switchport mode trunk
Raisecom(config-gigaethernet1/1/1)#switchport trunk allowed vlan 100-200
confirm
Raisecom(config-gigaethernet1/1/1)#exit
Raisecom(config)#interface gigaethernet 1/1/2
Raisecom(config-gigaethernet1/1/2)#switchport mode trunk
Raisecom(config-gigaethernet1/1/2)#switchport trunk allowed vlan 100-200
confirm
Raisecom(config-gigaethernet1/1/2)#exit
Step 2 Configure GE 1/1/1 as the primary interface of VLANs 100–150 and GE 1/1/2 as the backup
interface.
Raisecom(config)#interface gigaethernet 1/1/1
Raisecom(config-gigaethernet1/1/1)#port backup gigaethernet 1/1/2
vlanlist 100-150
Raisecom(config-gigaethernet1/1/1)#exit
Step 3 Configure GE 1/1/2 as the primary interface of VLANs 151–200 and GE 1/1/1 as the backup
interface.
Raisecom(config)#interface gigaethernet 1/1/2