Raisecom ISCOM2600G-HI (A) Series - Configuring Maximum Number of Ndps Allowed to be Learnt on Layer 3 Interface; Checking Configurations; Maintenance

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
5 IP services
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
219
5.4.6 Configuring maximum number of NDPs allowed to be learnt
on Layer 3 interface
Configure the maximum number of NDPs allowed to be learnt on the Layer 3 interface for the
ISCOM2600G-HI series switch as below.
Step
Command
Description
1
Raisecom#config
Enter global configuration mode.
2
Raisecom(config)#ipv6
neighbors max-learning-num
number
Configure the maximum number of NDPs
allowed to be learnt on the Layer 3 interface.
5.4.7 Checking configurations
Use the following commands to check configuration results.
No.
Command
Description
1
Raisecom#show ipv6
neighbors
Show all NDP neighbor information.
2
Raisecom#show ipv6
neighbors ipv6-address
Show neighbor information about a specified
IPv6 address.
3
Raisecom#show ipv6
neighbors vlan vlan-id
Show neighbor information about a specified
layer 3 interface.
4
Raisecom#show ipv6
neighbors static
Show information about IPv6 static neighbor.
5
Raisecom#show ipv6
interface nd [ ip if-
number ]
Show ND information configured on the
interface.
5.4.8 Maintenance
Maintain the ISCOM2600G-HI series switch as below.
Command
Description
Raisecom(config)#clear ipv6
neighbors
Clear information about all IPv6 neighbors.