Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Checking results
Use the show ip source binding command to show configurations of the static binding table.
Raisecom#show ip source binding
History Max Entry Num: 1
Current Entry Num: 1
Ip Address Mac Address VLAN Port
Type Inhw
-------------------------------------------------------------------------
----------------------------------
10.10.10.1 -- -- gigaethernet1/1/2
static yes
Use the show ip verify source command to show interface trusting status and configurations
of IP Source Guard static/dynamic binding.
Raisecom#show ip verify source
Static Bind: Enable
Dhcp-Snooping Bind: Enable
Port Trust
----------------------------------------
gigaethernet1/1/1 yes
gigaethernet1/1/2 no
gigaethernet1/1/3 no
gigaethernet1/1/4 no
gigaethernet1/1/5 no
gigaethernet1/1/6 no
gigaethernet1/1/7 no
……
10.9 PPPoE+
10.9.1 Introduction
PPPoE Intermediate Agent (PPPoE+) is used to process authentication packets. PPPoE+ adds
more information about access devices into the authentication packet to bind account and
access device so that the account is not shared and stolen, and the carrier's and users' interests
are protected. This provides the server with enough information to identify users, avoiding
account sharing and theft and ensuring the network security.
In PPPoE dial-up mode, you can access the network through various interfaces on the device
as long as authentication by the authentication server is successful.
However, the server cannot accurately differentiate users just by the authentication
information, which contains the user name and password. With PPPoE+, besides the user
name and the password, other information, such as the interface ID, is included in the
authentication packet for authentication. If the interface ID identified by the authentication
To Next Page
Loading...
Need help?
General
