Raisecom ISCOM2600G-HI (A) Series - Configuring Cos Remarking; Checking Configurations

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
7 QoS
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
298
Step
Command
Description
3
Raisecom(dscp-mutation)#dscp dscp-
value to new-dscp new dscp-value
(Optional) modify the DSCP
mutation profile. The profile used
in this configuration is the same
profile used by the mapping from
DSCP to local priority.
4
Raisecom(dscp-mutation)#exit
Raisecom(config)#interface
interface-type interface-number
Enter physical layer interface
configuration mode.
5
Raisecom(config-
gigaethernet1/1/1)#mls qos dscp-
mutation profile-id
Apply the DSCP mutation profile
on the interface.
7.2.7 Configuring CoS remarking
Configure CoS remarking for the ISCOM2600G-HI series switch as below.
Step
Command
Description
1
Raisecom#config
Enter global configuration mode.
2
Raisecom(config)#interface
interface-type interface-number
Enter physical layer interface
configuration mode.
3
Raisecom(config-
gigaethernet1/1/1)#mls qos cos-
remark-mapping enable
Raisecom(config-
gigaethernet1/1/1)#exit
Enable CoS remarking on the interface.
4
Raisecom(config)#mls qos
mapping cos-remark profile-id
Create a CoS remarking profile, and
enter cos-remark configuration mode.
5
Raisecom(cos-remark)#local-
priority localpri-value to cos
newcos-value
Modify the CoS remarking profile.
6
Raisecom(dscp-remark)#exit
Raisecom(config)#interface
interface-type interface-number
Enter physical layer interface
configuration mode.
7
Raisecom(config-
gigaethernet1/1/1)#mls qos cos-
remark profile-id
Apply the DSCP remarking profile on
the interface.
7.2.8 Checking configurations
Use the following commands to check configuration results.
No.
Command
Description
1
Raisecom#show mls qos interface
[ interface-type interface-
number ]
Show QoS priority, trust mode, and
scheduling mode on the interface.