Raisecom ISCOM2600G-HI (A) Series - Configuring MLD Snooping

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
8 Multicast
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
357
Step
Command
Description
1
Raisecom#config
Enter global configuration mode.
2
Raisecom(config)#mld mrouter
vlan vlan-id interface-type
interface-number
Create a multicast router interface on the
specified VLAN.
3
Raisecom(config)#mld ring
i nterface-type interface-
number
Enable MLD ring network forwarding
on the interface.
4
Raisecom(config)#interface
i nterface-type interface-
number
Raisecom(config-
gigaethernet1/1/port)#mld
immediate-leave [ vlan vlan-
list ]
(Optional) enable immediate leave of
MLD on the interface or
interface+VLAN.
If immediate leave is disabled on the
downlink interface, the router interface,
after receiving a Leave packet, will
calculate the aging time according to
robust factor and configure the
expiration time for a member to leave
the group as Group Membership Interval
(GMI). GMI = robust-
value*lastmember-queryinterval.
5
Raisecom(config)#mld report-
suppression
(Optional) enable Report suppression.
When receiving multiple Report packets
from the same group in a specified
period, the ISCOM2600G-HI series
switch forwards only one Report packet
to the router interface while it suppresses
others.
6
Raisecom(config)#mld member-
timeout { second |
infinite }
(Optional) configure the aging time of
MLD members.
7
Raisecom(config)#mld version
{ 1 | 2 }
Configure the MLD version.
8
Raisecom(config)#interface
interface-type interface-
number
Raisecom(config-
gigaethernet1/1/port)#mld
snooping host-join group-
address vlan vlan-id
Configure the host joining function for
MLD Snooping.
8.8.5 Configuring MLD Snooping
Configure MLD Snooping for the ISCOM2600G-HI series switch as below.
Step
Command
Description
1
Raisecom#config
Enter global configuration mode.
2
Raisecom(config)#mld snooping
Enable global MLD Snooping.