Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Raisecom(config)#igmp mvr
mcast-vlan
vlan-id
group
{
start-ip-address
[
end-ip-
address
] | any }
Configure the group address set for
multicast VLAN.
After IGMP MVR is enabled, you
need to configure multicast VLAN
and bind group address set. If the
received IGMP Report packet does
not belong to a group address set
of any VLAN, it is not processed
and the user cannot make multicast
traffic on demand.
Raisecom(config)#interface
interface-type interface-
number
Enter interface configuration mode.
Raisecom(config-
gigaethernet1/1/port)#igmp
mvr mcast-vlan
vlan-id
static
ip-address
user-vlan
vlan-id
(Optional) configure static multicast
members of MVR for a specified
customer VLAN.
Raisecom(config-
gigaethernet1/1/port)#igmp
mvr user-vlan
vlan-id
(Optional) configure the range for
multicast inter-VLAN copy to take
effect.
IGMP Snooping and IGMP MVR cannot be enabled concurrently in the same
multicast VLAN. Otherwise, the configuration will fail.
IGMP Snooping and multicast VLAN copy cannot be enabled concurrently in the
same multicast VLAN. Otherwise, the configuration will fail.
8.5.5 Checking configurations
Use the following commands to check configuration results.
Raisecom#show igmp mvr
{ interface |
interface-type
interface-number
}
Show configurations of IGMP MVR on
the specified interface.
Raisecom#show igmp mvr member
[
interface-type interface-
number
| user-vlan
vlan-id
]
Show information about multicast
group members of IGMP MVR.
Raisecom#show igmp mvr member
count {
interface-type
interface-number
| user-vlan
vlan-id
}
Show the number of multicast group
members of IGMP MVR.
Raisecom#show igmp mvr vlan-
group [ mcast-vlan
vlan-id
]
Show multicast VLAN and its group
address set.
To Next Page
Loading...
Need help?
General
