Raisecom ISCOM2600G-HI (A) Series - 5 IP Services; IP Basis; Introduction; Preparing for Configurations

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
5 IP services
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
207
5 IP services
This chapter describes basic principles and configuration procedures for IP services, and
provides related configuration examples, including the following sections:

IP basis

Loopback interface

ARP

NDP

Static route

RIP

OSPFv2
5.1 IP basis
5.1.1 Introduction
The IP interface is the virtual interface based on VLAN. Configuring Layer 3 interface is
generally used for network management or routing link connection of multiple devices.
The ISCOM2600G-HI series switch supports double-tagged management VLAN packets; in
other words, it can send and process double-tagged packets.
5.1.2 Preparing for configurations
Scenario
Configure the IP address of each VLAN interface and loopback interface.
Prerequisite

Create VLANs.

Activate them.
5.1.3 Default configurations of Layer 3 interface
Default configurations of the Layer 3 interface are as below.