Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Raisecom#download system-boot
{ ftp {
ipv4-address | ipv6-
address
}
user-name password
file-name
| tftp {
ipv4-address
| ipv6-address
}
file-name |
s
ftp {
ipv4-address | ipv6-
address
}
user-name password
file-name
} [ system1.z |
system2.z ]
Download the system boot file through
FTP, SFTP, or TFTP. This command
supports the IPv6 address.
(Optional) configure the sequence for
loading system software.
Restart the ISCOM2600G-HI series
switch, and it will automatically load
the downloaded system boot file.
1.4.4 Checking configurations
Use the following commands to check configuration results.
Raisecom#show
startup-config
Show information about the startup configuration file.
Raisecom#show
running-config
Show information about the running configuration file.
1.5 Automatically updating version and configurations
1.5.1 Introduction
After being powered on, the ISCOM2600G-HI series switch can automatically obtain the new
version and configurations. After obtaining an IP address as a DHCP client, it will
automatically download configuration files and system files from the TFTP server to update
version and configurations.
1.5.2 Preparing for configurations
Scenario
To use the ISCOM2600G-HI series switch as a DHCP client, you must enable DHCP Client.
The DHCP client actively sends a Discover broadcast packet. After receiving the packet, the
DHCP server pads information, such as the assigned IP address to the Offer packet, and sends
the packet to the DHCP client. Meanwhile, it pads the IP address of the TFTP server to Option
150 and pads the name of the configuration file or system file to Option 67. After receiving
To Next Page
Loading...
Need help?
General
