Raisecom ISCOM2600G-HI (A) Series User Manual

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
12 System management
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
529
Step
Command
Description
1
Raisecom#conf
ig
Enter global configuration mode.
2
Raisecom(conf
ig)#clear
alarm
Clear alarms manually.
Use this command to clear all alarms in current
alarm list and generate an all-alarm alarm in history
alarm list.
If enabling global sending Trap, the all-alarm alarm
will be output in Trap mode; if enabling global
Syslog, the all-alarm alarm will be output in Syslog
mode.
12.7.8 Checking configurations
Use the following commands to check configuration results.
No.
Command
Description
1
Raisecom#show alarm
Show global hardware environment
monitoring alarm configurations.
2
Raisecom#show alarm
current
Show current alarms of hardware environment
monitoring.
3
Raisecom#show alarm
history
Show history alarms of hardware environment
monitoring.
4
Raisecom#show
environment
[ temperature | power ]
Show information about the current
environment, such as power supply,
temperature, and alarms.
12.8 CPU monitoring
12.8.1 Introduction
The ISCOM2600G-HI series switch supports CPU monitoring. It can monitor state, CPU
utilization rate, and application of stacking of each task in real time in the system. It helps
locate faults.
CPU monitoring can provide the following functions:

Viewing CPU utilization rate
It can be used to view unitization of CPU in each period (5s, 1minute, 10minutes, 2hours).
Total unitization of CPU in each period can be shown dynamically or statically.

Raisecom ISCOM2600G-HI (A) Series Specifications

General

Brand	Raisecom
Model	ISCOM2600G-HI (A) Series
Category	Switch
Language	English